Reinstall Covers (Frames R3...R8); Frames Action - ABB ACS560 Quick Installation And Start-Up Manual

ACS560R0-R8 QIG.book Page 20 Wednesday, May 30, 2018 3:45 PM
￭ Reinstalling side plates and covers, frames size R5...R8
ACS560R0-R8 QIG.book Page 20 Wednesday, May 30, 2018 3:45 PM
20 EN - Quick installation and start-up guide
1. Reinstall the module cover. Put the tabs on the cover top in their counterparts on
the housing and then press the cover.
2. Tighten the two retaining screws with a screwdriver.
20 EN - Quick installation and start-up guide

Reinstall covers (frames R3...R8)

1. Reinstall the cover: Put the tabs on the cover top in their counterparts on the housing and
Reinstall covers (frames R3...R8)
press the cover.
1. Reinstall the cover: Put the tabs on the cover top in their counterparts on the housing and
2. Tighten the retaining screw at the bottom with a screwdriver.
press the cover.
2. Tighten the retaining screw at the bottom with a screwdriver.
EN
EN
If cable conduit box is used, perform the following:
If cable conduit box is used, perform the following:
If cable conduit box is used, perform the following:

Frames Action

Frames
Frames Action
R5 1. Slide the cover upwards (1a) and tighten the retaining screws (1b).
R5
R5
2. Reinstall the module cover (2a) and press the cover at bottom. Tighten the two
ES
FI
FR
R6...R8
IT
PL
PT
Action
1. Slide the cover upwards (1a) and tighten the retaining screws (1b).
1. Slide the cover upwards (1a) and tighten the retaining screws (1b).
2. Reinstall the module cover (2a) and press the cover at bottom. Tighten the
2. Reinstall the module cover (2a) and press the cover at bottom. Tighten the two
two retaining screws (2b) with a screwdriver.
retaining screws (2b) with a screwdriver.
retaining screws (2b) with a screwdriver.
1b
1a
1. Install the side plates (1a) of the cable box. Tighten the retaining screws (1b)
with a screw driver.
2. Slide the cover (2a) of the cable box on the module from below until the cover
snaps into place.
3. Reinstall the module cover (3a). Tighten the two retaining screws (3b) with a
screwdriver.
EN - Quick installation and start-up guide 31
1b
1b
1b
1a
EN
HI
2a
2a
2b
2b