Siemens SINUMERIK 840Di Diagnostic Manual page 844

List of Action Numbers
No. 69
Explanation Activate program test (VDI signal: Program test).
Cause 1. Tool management is active.
2. The NCK channel is in a state other than "ready".
− Backing up tool data
Remedy
− Abort the program or process with the Reset key or
− wait for end of program
No. 70
Explanation Deactivate program test (VDI signal: Program test).
Cause The NCK channel is in a state other than "ready".
− Abort the program or process with the Reset key or
Remedy
− wait for end of program
No. 71
Explanation Stop at the end of block preparation (alarm)
Cause -
Remedy -
No. 72
Explanation Stop at the end of block preparation with subsequent reorganization of block processing
(alarm)
Cause Nesting depth too great
− Wait until the preceding ASUB is complete or
Remedy
− Abort program
No. 73
Explanation Conditional stop at block end. If, after continuation by means of an NC Start, there is still
a reason to stop "Stop at block end", the program stops again.
Cause -
Remedy -
3-844
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006