Siemens SINUMERIK 840Di Diagnostic Manual page 558
Hide thumbs
Also See for SINUMERIK 840Di:
- Function manual (2050 pages) ,
- Manual (552 pages) ,
- System overview (55 pages)
Table of Contents
Advertisement
Overview of Alarms
NCK alarms
61557
Channel %1 block %2: Impossible chamfer and radius of right edge of
wheel
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
61558
Channel %1 block %2: Chamfer / radius + shoulder height are less than
the retraction height of the left edge of the grinding wheel
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
61559
Channel %1 block %2: Chamfer / radius + shoulder height are less than
the retraction height of the right edge of the grinding wheel
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy:
Check values in grinding wheel data
61601
Channel %1 block %2: Finished part diameter too small
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed radius of the machined part is too small. Alarm triggered by following cycles:
CYCLE94, CYCLE96.
Remedy:
Check parameter SPD or DIATH.
61602
Channel %1 block %2: Tool width incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Plunge cutter is larger than the programmed groove width. Alarm triggered by following cycle:
CYCLE93.
Remedy:
Check tool or change program.
61603
Channel %1 block %2: Recess type incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element
running parallel to the longitudinal axis is not possible. Alarm triggered by following cycle: CYCLE93.
Remedy:
Check parameter VARI.
2-558
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006
Hide quick links:
Advertisement
Table of Contents
