Motorola MVME2400 Series Installation And Use Manual page 39

Inserting or removing modules with power applied may result in damage
!
to module components.
Caution
Dangerous voltages, capable of causing death, are present in this
!
equipment. Use extreme caution when handling, testing, and adjusting.
Warning
3. If the Primary PMC Carrier Module/MVME240x assembly is
Avoid touching areas of integrated circuitry; static discharge can damage
!
these circuits.
Caution
4. Remove the four short Phillips screws from the standoffs in each
5. Attach the four standoffs to the PMCspan-002.
6. Place the PMCspan-010 on top of the PMCspan-002. Align the
7. Gently press the two PMCspan modules together, making sure that
8. Insert the four short Phillips screws through the holes at the corners
Note
http://www.motorola.com/computer/literature
already installed in the VME chassis, carefully remove the two-
board assembly from the VMEbus card slots and lay it flat, with the
P1 and P2 connectors facing you.
corner of the primary PCI expansion module, PMCspan-002.
mounting holes in each corner to the standoffs, and align PMCspan-
010 connector P3 with PMCspan-002 connector J3.
P3 is fully seated in J3.
of PMCspan-010 and into the standoffs on the primary PMCspan-
002. Tighten the screws.
The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Hardware Installation
1-19
1