Pmc Preparation; Pmcspan Preparation; System Console Terminal Preparation - Motorola MVME2400 Series Installation And Use Manual

PMC Preparation

For a discussion of any configurable items on the PMCs, refer to the user's
manual for the particular PMCs.

PMCspan Preparation

You will need to use an additional slot in the VME chassis for each
PMCspan expansion module you plan to use. Before installing a PMCspan
on the MVME240x, you must install the selected PMCs on the PMCspan.
Refer to the PMCspan PMCAdapter Carrier Module Installation and Use
manual for instructions.

System Console Terminal Preparation

Ensure that the switches are set in the proper position for all bits on switch
S3 of the MVME240x board as shown in
when the PPCBug firmware is used. Connect the terminal via a cable to the
RJ-45 DEBUG connector J2. See
assignments. Set up the terminal as follows:
http://www.motorola.com/computer/literature
Eight bits per character
One stop bit per character
Parity disabled (no parity)
Baud rate = 9600 baud (default baud rate of the port at power-up);
after power-up, you can reconfigure the baud rate with PPCBug's
PF command
Figure 1-2. This is necessary
Table B-3 on page B-5
PMC Preparation
for pin signal
1-11
1