Starting Up Cycle800 - Siemens SINUMERIK 840D Programming Manual

3
Milling Cycles
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)

3.16.4 Starting up CYCLE800

When CYCLE800 is started up, the data (swivel data record) is set
in the tool data $TC_CARR1...40. This is grouped to form Swivel
start-up menus.
à Operating area "Start-up"; Soft key "Swivel cycle"
References: for current infos see:
• the file "siemensd.txt" from the delivery software (standard cycles) or
• for HMI Advanced, F:\dh\cst.dir\HLP.dir\siemensd.txt.
The following cycles must be loaded:
• CYCLE800.SPF, CYCPE_SC.SPF (standard cycles)
• TOOLCARR-SPF (user cycle)
• PROG_EVENT.SPF (manufacturer cycle).
The GUD variables _TC_FR to _TC_NUM (GUD7.def)
must be activated.
Machine data
To use the swiveling cycle, the machine data below must be set as
follows (minimum requirement):
• Machine data with an exact value assignment (G)
à is machine data that must not be changed
• Machine data with a variable value assignment (V)
à is machine data where the default value can be set
to a higher or lower value.
MD No. MD identifiers
10602 $MN_FRAME_GEOAX_CHANGE_MODE
11450 $MN_SEARCH_RUN_MODE
18088 $MN_MM_NUM_TOOL_CARRIER
20108 $MC_PROG_EVENT_MASK
20110 $MC_RESET_MODE_MASK
20112 $MC_START_MODE_MASK
21100 $MC_ORIENTATION_IS_EULER
20126 $MC_TOOL_CARRIER_RESET_VALUE
20150 $MC_GCODE_RESET_VALUES[41]
20150 $MC_GCODE_RESET_VALUES[51]
20150 $MC_GCODE_RESET_VALUES[52]
1) For note on machine data, see next page
3-238
Value Comments
1)
1
1)
Bit 1=1
n à Number of swivel data records
n>0
0 -
'H4041' Bit 14=1
'H400' -
0 Angles of rotations are interpreted as
RPY
0...n is described in CYCLE800
1)
1 TCOABS
1)
2 PAROT
1)
1 TOROT
(for kinematics type T and M only)
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
11.02
Can be
changed
V
G
1)
G
V
G
G
G
V
G
G
V
© Siemens AG, 2002. All rights reserved