Siemens SINUMERIK 840D Programming Manual page 354

5
Error Messages and Error Handling
5.3 Overview of cycle alarms
Alarm number
61604
61605
61606
61607
61608
61609
61610
61611
61612
61613
61803
61807
62100
62105
62180
62181
5-354
Alarm text
"Active tool violates
programmed
contour"
"Contour incorrectly
programmed"
"Error on contour
preparation"
"Starting point
incorrectly
programmed"
"Wrong tool point
direction programmed"
"Form incorrectly
programmed"
"No infeed depth
programmed"
"No intersection
found"
"Thread cannot be
recut"
"Undercut position
incorrectly defined"
"Programmed axis
does not exist"
"Incorrect spindle
direction programmed
(active)"
"No drilling cycle
active"
"Number of columns
or rows is zero"
"Set rotary axes x.x
[deg]"
"Set rotary axes x.x
[deg]"
Source Explanation, remedy
CYCLE95 Contour violation in relief cut elements as a
result of the clearance angle of the tool
being used, i.e. use a different tool or
check the contour subroutine
CYCLE76 Illegal relief cut element detected
CYCLE77
CYCLE95
CYCLE95 An error was detected during contour
preparation, this alarm is always output
with NCK alarm 10930 ... 10934, 15800 or
15810
CYCLE95 The starting point reached before the cycle
was called does not lie outside the rec-
tangle described by the contour subroutine
CYCLE94 A tool point direction between 1 ... 4 that
CYCLE96 matches the undercut form must be
programmed
CYCLE94 Check parameters for the undercut
CYCLE96 form
CYCLE76
CYCLE77
CYCLE96
CYCLE95 The system cannot calculate an inter-
section with the contour. Check contour
programming or change infeed depth
CYCLE97
CYCLE98
CYCLE94 Check value in parameter _VARI
CYCLE96
CYCLE83 Check parameter _AXN
CYCLE84
CYCLE840
CYCLE840 Check parameters SDR and SDAC
HOLES1 No drilling cycle was called modally be-
HOLES2 fore the drilling pattern cycle was called
CYCLE800
CYCLE800 Angles to be set for manual rotary axes
CYCLE800 Angle to be set for manual rotary axis
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
5
03.96
09.01
© Siemens AG, 2002. All rights reserved