Table Of Contents - Siemens SINUMERIK 840D Programming Manual

0
11.02
Contents
General .......................................................................................................... 1-17
1.1 General information......................................................................................................... 1-18
1.2 Overview of cycles .......................................................................................................... 1-18
1.2.1 Drilling cycles, drill pattern cycles, milling cycles and turning cycles......................... 1-19
1.2.2 Cycle auxiliary subroutines........................................................................................ 1-20
1.3 Programming cycles........................................................................................................ 1-21
1.3.1 Call and return conditions ......................................................................................... 1-21
1.3.2 Messages during execution of a cycle ...................................................................... 1-22
1.3.3 Cycle call and parameter list ..................................................................................... 1-23
1.3.4 Simulation of cycles .................................................................................................. 1-26
1.4 Cycle support in program editor (SW 4.3 and higher)..................................................... 1-27
1.4.1 Overview of important files........................................................................................ 1-28
1.4.2 Configuring cycle selection........................................................................................ 1-29
1.4.3 Configuring input screen forms for parameter assignment....................................... 1-31
1.4.4 Configuring help displays .......................................................................................... 1-34
1.4.5 Configuring tools (MMC 100 / MMC 100.2 only) ....................................................... 1-35
1.4.6 Loading to the control................................................................................................ 1-36
1.4.7 Independence of language........................................................................................ 1-37
1.4.8 Operating the cycles support function....................................................................... 1-38
1.4.9 Integrating user cycles into the MMC 103 simulation function .................................. 1-38
1.4.10 Typical user cycle configuration ................................................................................ 1-39
1.5 Cycle support in program editor (SW 5.1 and higher).................................................... 1-40
1.5.1 Menus, cycle selection .............................................................................................. 1-40
1.5.2 New functions in input screen forms ......................................................................... 1-41
1.6 Cycle support for user cycles (SW 6.2 and higher)........................................................ 1-48
1.6.1 Overview of important files........................................................................................ 1-48
1.6.2 Entry to cycle support................................................................................................ 1-48
1.6.3 Cycle support configuration....................................................................................... 1-49
1.6.4 Bitmap size and screen resolution ............................................................................ 1-50
1.6.5 Storing bitmaps in data management for HMI Advanced ......................................... 1-51
1.6.6 Handling bitmaps for HMI Embedded ....................................................................... 1-51
1.7 Cycle startup (SW 6.2 and higher) ................................................................................. 1-53
1.7.1 Machine data............................................................................................................. 1-53
1.7.2 Definition files for the cycles GUD7.DEF and SMAC.DEF........................................ 1-54
1.7.3 New form of delivery for cycles in HMI Advanced..................................................... 1-55
1.8 Special functions for cycles ............................................................................................ 1-56
ã Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) - 11.02 Edition
0
Contents
0-5