Hitachi HF-W100E Instruction Manual page 82

3. SETUP
● Windows® Embedded Standard 7 setup procedure
Perform the following procedure to set up Windows® Embedded Standard 7.
1. Remove the external storage device from the equipment if it is connected to this
equipment.
2. Turn on this equipment.
Windows starts running and setup is prepared.
Then, the message "Setup is installing devices. Please wait..." appears, indicating that
installation of the device driver is in progress.
• This processing may take several minutes. Please wait until it is completed.
After a while, the Windows® Embedded Standard 7 setup window opens.
3. A window is displayed to select a display language.
Select a display language and then click Next. For example, if you want to select the
English language, select My language is English from the list.
(It should be noted that the language used in the window is changed to the specified
display language immediately after you select the language.)
The correspondence between the display language and the notation in the list is as in the
table below. (In the same order as in the list)
Display language
English
Japanese
< NOTE >
・ If you select Japanese, RAS software for Japanese environment will be
installed, so if you have the possibility of switching to a language other than
Japanese for overseas later, select English and select the English version of
RAS software Please be sure to install it.
4. The country or region, time and currency format, keyboard layout setting screen is
displayed.
· If you selected English with step 3, click Next with the settings as it is.
· If you selected Japanese with step 3, set the country / region, time and currency
format, keyboard layout, if necessary, and click Next. At this time, please
select "日本語 (日本)" for the time and currency format.
5. The user name input window is displayed.
· Enter the user name and the computer name and click Next.
Notation in the list
My language is English
私の言語: 日本語
3-2