Hitachi HF-W100E Instruction Manual page 202

9. TROUBLESHOOTING
(5) The screen flickers or blacks out.
<Possible cause>
There is an error in the display.
<Action>
1. Make sure that the power cable for the display is plugged into the outlet.
2. Make sure that the equipment and the display are connected through a display interface
cable. (Check if the connection of the cable is not loose.)
3. Replace the display interface cable with a new one. (Check that the cable is broken.)
4. Re-examine the display settings. For information about how to adjust the display, refer to
the manual of the display.
5. When you use the display which supports MST (Multi Stream Transport) of the
DisplayPort, make sure the following items. (Refer to the manual attached to the display for
the setting.)
i) If the Display can change the DisplayPort1.1 and the DisplayPort1.2, select the the
DisplayPort1.2.
ii) If the display can change the setting of MST, set it to "Primary".
< NOTE >
If MST is enabled, the item of "Display Port topology" is displayed when you right-
click on the desktop window.
(6) In the screen resolution setting, an unconnected display is shown.
<Possible cause>
It is possible that an unconnected display is shown due to the specifications of the OS.
<Action>
1. Right-click on the desktop to display a pop-up menu. Click Screen resolution.
2. In the screen resolution setting window, select an unconnected display.
3. Under Multiple Displays, select Delete this display. If this setting change is not applied
automatically, click Apply to delete the unconnected display.
4. If multiple unconnected displays are shown, repeat steps 2 and 3.
9-8