5
Adjustment > Auxiliary Adjustment > Adjusting Saddle Stitching Position > Procedure
Adjusting Saddle Stitching Position
Execute this adjustment in the case of displacement in stitching position (saddle delivery) or
replacing the finisher controller PCB.
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
• In the case of A-configuration [2]]
• In the case of L-configuration [3]
Then, press SW385 so that the adjustment is ready now.
[2]
[3]
5
Adjustment > Auxiliary Adjustment > Adjusting Saddle Stitching Position > Procedure
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
F-5-204
2) Hold the lever [1] to pull out the saddle unit [2], and then open the saddle right guide [3].
[2]
[1]
3) Follow the feed guide to set the paper (A4R or LTRR) [1].
(Be sure to push in the paper until it touches the positioning plate).
[3]
F-5-205
[2]
[1]
F-5-206
5-89
5-89