Removing The Front Alignment Motor; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Front Alignment Motor > Procedure
2) Free the cable [2] from the 2 Wire Saddles, and disconnect the connector [3].
3) Remove the Process Tray Plate Unit [1].
• 6 Screws [2]
• 2 Positioning Plates [3]
x3
[2]
[3]
[2]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Front Alignment Motor > Procedure
x2
[2]
[1]
[3] [1]
F-4-173
[1]
[3]
[2]
x3
[2]
F-4-174

Removing the Front Alignment Motor

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Process Tray (Front).(Refer to page 4-68)
6) Remove the Stack Delivery Motor.(Refer to page 4-72)
7) Remove the Process Tray Plate Unit.(Refer to page 4-72)

■ Procedure

CAUTION:
When replacing or installing/removing the Front Alignment Motor, be sure to perform the
following adjustment.
• Adjusting Right Angle of the Alignment Plate (Refer to page 4-77)
• Adjusting the Alignment Plate Width (Refer to page 5-27)
4-73
4-73