Canon Booklet Finisher-D1 Service Manual page 189

5
Adjustment > Adjustment at Time of Parts Replacement > Outline
Adjustment Type Symptom, adjustment timing
Adjusting Saddle When replacing the Finisher Controller PCB
Stitching Position
Adjusting Saddle
Folding Position
Adjusting Position of
Saddle Lead Edge
Stopper
Adjustment After
Replacing Finisher
Controller PCB
Bufferless Mode
Adjustment in the Case
of Failure in Stacking
Performance of Tray
(upper curl)
Adjustment in the Case
of Failure in Stacking
Performance of Tray
(lower curl)
Adjustment in the Case
of Failure in Stacking
Performance of Tray
(run-on of paper when
using thin paper)
Adjustment in the Case
of Canceling Limit for
Tray Stack
Adjusting Alignment for When replacing the Saddle Stapler
Saddle Stapling
5 Adjustment > Adjustment at Time of Parts Replacement > Outline
Reference
p. 5-48
p. 5-50
p. 5-51
p. 5-53
p. 5-54
p. 5-55
p. 5-57
p. 5-59
p. 5-61
p. 5-63
T-5-5
5-13
5-13