Removing The Process Upper Guide Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Upper Guide Unit > Procedure

Removing the Process Upper Guide Unit

■ Preparation

1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Open the Front Cover.
7) Remove the Inner Cover (Upper).(Refer to page 4-22)

■ Procedure

1) Free the 2 harnesses [1].
• 3 Wire Saddles [2]
• 1 Edge Saddle [3]
• 3 Connectors [4]
[4]
[1]
[1] [4]
[4]
x2
x4
[3] [2]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Upper Guide Unit > Procedure
2) Remove the 2 screws [1] of the Front Plate.
3) Remove the 2 screws [1] of the Rear Plate.
x2
F-4-185
[2]
x2
4-78
[1]
F-4-186
4-78