Motors; Removing The Front Alignment Motor (M107); Removing The Rear Alignment Motor (M108) - Canon Staple Finisher-AA1 Service Manual

Motors

Removing the Front Alignment
Motor (M107)
■ Preparation
1. Lower the stack tray.
2. Remove the stack tray.
" Removing the Stack Tray" on page 96
3. Remove the grate-shaped lower guide.
" Removing the Grate-Shaped Lower Guide" on page
96
4. Remove the side covers (front and rear) [1] [2].
• 1 screw [3] each
2x
[3]
[1]
5. Remove the processing tray.
" Removing the Processing Tray" on page 102
■ Procedure
1. Remove the motor [1].
• 2 screws [2]
• 1 connector [3]
Removing the Rear Alignment
Motor (M108)
■ Preparation
1. Lower the stack tray.
2. Remove the stack tray.
" Removing the Stack Tray" on page 96
3. Remove the grate-shaped lower guide.
" Removing the Grate-Shaped Lower Guide" on page
[2]
96
4. Remove the side covers (front and rear) [1] [2].
• 1 screw [3] each
5. Remove the processing tray.
" Removing the Processing Tray" on page 102
123
4. Parts Replacement and Cleaning
[2]
[3]
2x
1x
[1]
2x
[3]
[1]
[2]