Commissioning - Bosch PSI 6XXX.350 L1 Series Technical Information

9

Commissioning

1070 080 067-101 (2001.03) GB
PSI 6XXX.350 L1
NOTE
For commissioning, please note the safety instructions, the technical data and the electri-
cal wiring diagrams.
The following sections contain suggestions on how to proceed during commissioning.
Acceptance of these suggestions will depend on the specific circumstances and will be
the responsibility of the commissioning personnel.
Concerning the status messages of the timers, please refer to the BOS-5000 software
and to section 10, Messages.
The following components are necessary for commissioning:
- programming terminal with V24 interface and Windows operating system,
suitable interface boards in the programming terminal and the weld timers if field
bus installations are used.
- BOS-5000 software
- V24 interface cable, cf. section 7.1.1, suitable field bus cables for field bus installa-
tions.
Communication between the programming terminal and the timers is via the V24, the I/O
interface as the programming terminal interface or via the field bus interfaces (e.g. Profi-
bus). In Online mode, all Welding Parameters are saved to the timer.
You can save the Welding Parameters in the programming terminal in preparation of
commissioning (offline timer).
The BOS-5000 software must be switched to online mode, and the terminal must
D
be connected to the timer or the networked timers.
Prerequisite:
- Timer Reference has been performed.
For more information on these issues, please refer to the following documentation bro-
chures:
- Operating and Programming Manual BOS-5000, volume 1, part no. 1070 078 217
- Operating and Programming Manual BOS-5000, volume 2, part no. 1070 078 218
NOTE
If any welding parameters have already been programmed in the timer, you should first
save these parameters with the Upload (Backup) function.
Select Operation - Services - Upload (Backup).
Commissioning
9-1