Table of Contents
Advertisement
PSI 6XXX.350 L1
Electrical connection
Start
t
actual pres-
sure P
act
100%
90%
t
closing time in ms
Figure 21: Pressure gauging
Pressure gauging:
You can initiate pressure gauging by setting the parameter <Export pressure value>.
First, the <Operate> signal is set. Every time, the <Actual pressure> parameter is ac-
cessed, the pressure is measured. When the <Export pressure value> parameter is re-
set, the <Operate signal> is reset and pressure gauging is terminated. The normal end
of a program sequence or a pressure check/calibration will also terminate the gauging
routine.
7-36
1070 080 067-101 (2001.03) GB
Advertisement
Table of Contents
