Line And Dc Link Identification - Siemens SINAMICS S120 Function Manual

Key parameters for Active Infeed (see List Manual)
S r0002
S r0046
S p0210
S p0211
S p0220
S p0280
S p0840
S p0844
S p0852
S p0898
S p0899
S p2138
S p2139
S p3400
S r3405
S p3510
S p3533
S p3610
S p3611
1.1.2

Line and DC link identification

Automatic parameter identification is used to determine all the line and DC link
parameters, thereby enabling the controller setting for the line module to be
optimized.
Note
If the line environment or DC link components are changed, automatic
identification should be repeated with p3410 = 5 (e.g. once the system has been
installed or the drive line-up extended).
When the identification function is activated, alarm A06400 is output.
© Siemens AG, 2005. All rights reserved
SINAMICS S120 Function Manual, 06/05 Edition
Infeed/operating display
CO/BO: Infeed missing enable signals
Device supply voltage
Rated line frequency
Infeed line filter type
DC link voltage maximum steady-state
BI: ON/OFF1
BI: 1. OFF2
BI: Enable operation
CO/BO: Control word sequential control infeed
CO/BO: Status word central probe
CO/BO: Control word faults/alarms
CO/BO: Status word faults/alarms 1
Infeed configuration word
CO/BO: Status word infeed
Infeed DC link voltage setpoint
BI: Infeed, inhibit regenerative operation
Infeed reactive current fixed setpoint
CI: Infeed reactive current supplementary setpoint
Supply
Active infeed
1-21