Controller Node Subsystem Status Display - ABB 800xA Operation

Section 6 Status Displays

Controller Node Subsystem Status Display

The Controller Subsystem Status Display,
specified node's general condition. The first line of the display below the Subsystem
Status title provides the device number, type and current state of the Controller
Subsystem. The other areas and activities are described below.
Figure 60. Controller Subsystem Status Display (Controller)
Controller Subsystem Status Display CCR Requests
The Redundancy Request button is used to make Control Card Redundancy (CCR)
requests for the selected Control Module. When one of the associated commands is
selected, the request and the currently selected subdevice number are shown and a
prompt is displayed requesting confirmation of the selected action. If the action and
the subdevice are correct, select Confirm to send the request. Otherwise, you can
select a different command or subdevice. Only when Confirm is selected
3BUR002418-600 A
Controller Node Subsystem Status Display
Figure 60, provides information on the
131