Local Coordinate System (G52) - Siemens SINUMERIK 802D sl Programming Manual

Movement Control Commands
3.1 The coordinate system
Creates
Reset behavior
G51.1: Mirroring
G51.1 X Y
Component
Creates
Reset behavior
G92: Set actual value
G92 X Y R
Component
Creates
Reset behavior
G10 L2 P0
G10 L2 P0
Component
Creates
Reset behavior
If all frames are created, it is no longer necessary for the ISO mode that the fra-
mes are configured using the FINE component. The machine data 18600:
$MN_MM_FRAME_FINE_TRANS need not be set to "1". If you switch from the
ISO mode to the Siemens mode and if the Siemens mode uses a function which
requires a fine offset (e.g. G58, G59), $MN_MM_FRAME_FINE_TRANS must re-
main "1".
3.1.7

Local coordinate system (G52)

3-52
$MC_MM_SYSTEM_FRAME_MASK Bit 8 = 1
Delete frame
$MC_CHSFRAME_RESET_MASKBit 8 = 0
$P_ISO1FRAME
TRANS, MIRROR
$MC_MM_SYSTEM_FRAME_MASK Bit 7 = 1
Delete frame
$MC_CHSFRAME_RESET_MASKBit 7 = 0
$P_SETFRAME
TRANS
$MC_MM_SYSTEM_FRAME_MASK Bit 0 = 1
Frame is maintained after RESET
$MC_CHSFRAME_RESET_MASKBit 0 = 1
$P_EXTFRAME
TRANS
$MC_MM_SYSTEM_FRAME_MASK Bit 1 = 1
Delete frame
$MC_CHSFRAME_RESET_MASKBit 1 = 0
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
© Siemens AG 2007 All rights reserved
04.07