Siemens SINUMERIK 802D sl Programming Manual page 243

04.07
Identifier Type
$C_I_NUM INT
$C_J_NUM INT
$C_K_NUM INT
$P_AP INT
$C_TYP_PROG INT
$C_PI INT
© Siemens AG 2007 All rights reserved
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) - - 04.07 Edition
Cycle programming: Value is always 1 if bit 0 set in $C_I_PROG.
Macro programming: Number of I addresses programmed in block (max. 10).
For description see $C_I_NUM
For description see $C_I_NUM
Polar coordinates 0 = OFF 1 = ON
Bit map of all programmed addresses in a block with a cycle call
Bit 0 = A
Bit 25 = Z
Bit = 0 axis programmed as INT
Bit = 1 axis programmed as REAL
Program number of the interrupt routine that was programmed with M96
Data Fields, Lists
Description
E.3 Variables
E-243