Panasonic PV500 User Manual page 79

Specifying Execution Mode and Number of Blocks
1.
Select "TYPE" > "Type Setting" from the menu bar.
"Type Setting" window is displayed.
2.
Select "Execution Condition".
3.
Select "Automatic Switch" for
"Execution Mode".
4.
Enter the number of blocks 2 to 10 for
"Number of Blocks".
Setting a Branch Condition
1.
Select "INSPECTION" > "Judgement" from
the menu bar.
The screen of Judgement setting is displayed.
2.
Select "Set Branch Condition".
The branch condition setting screen is displayed.
3.
Select "Block No.0".
Branch 0-8 are displayed.
(When the number of blocks is 10.)
Branch condition is the result of the external
output register (JDC) or the internal register
(JRC) of the judgement of the specified block.
Conditions are applied from the top. When the
result meets the set condition, the right end block
will be executed. When it does not meet, the next
branch will be executed.
In the example shown on the right, the setting of
the Branch 0 indicates that if judgement No.50 is
OK, Block 1 will be executed, if it is NG,
proceeds to Branch 1.
4.
Set branch conditions.
- Condition and Checker No.:
Specify Judgement type and number to set as a branch condition.
- Judgement:
Specify a condition to meet. When specifying "OK", the branch condition is satisfied if the result of the
set Judgement expression is OK.
As "Destination", you can set the block number that is larger than the currently setting block or "End".
For instance, Block 0 cannot be set as a branch destination for Block No.1.
"End" indicates to end the inspection.
To set the behavior when no branch conditions are fulfilled, select "Destination" field in "False" line.
Set branch conditions as necessary.
5.
Set branch condition of the destination block if needed.
6.
After setting is completed, press the CANCEL key.
77