4.10.2 Setting a Geometry Calculation
Selecting a Checker No. and a Type of Detect Mode
1.
Select "INSPECTION" > "Geometry Calc.".
2.
Select the checker No. list and specify a
checker number to set.
3.
Move the cursor onto a type of Geometry
Calculation to create.
The setting window of the selected type is displayed.
Selecting a Camera
Select a camera image to set "Geometry Calculation".
1.
Select a camera No. in "Camera" in the setting
window of "Geometry Calculation".
The image of the selected camera is displayed.
Select a displayed image type (Live/Memory and Gray/Binary) or magnification in "Image Menu" opened
by pressing the F1 key.
Setting a Reference
Specify the created checker to detect "Point" or "Line" which are necessary for Geometry Calculation.
1.
Select "Reference".
The items such as points or lines which are required for the selected
type of Geometry Calculation are listed.
Items to be specified vary depending on geometry calculations.
Refer to the next page for how to set an area.
Detect mode
Distance Point-Point
Intersecting Point
Median of Two Lines
Distance Point-Line
Approximate Line
Approximate Circle
Approximate Ellipse
·
Only the checkers set with the same camera can be referred.
·
The procedure for setting "Distance Point-Line" is the same as those for setting "Point" in "Distance
Point-Point" and "Line" in "Intersecting Point".
212
Input item
Point 0, Point 1
Line 0, Line 1
Point 0, Line 1
Point 0 to Point 9
2 points or more
or
3 points or more
All points
6 points or more