The Mode/Trigger Screen; Overview - HP 81101A Quick Start Manual

Hide thumbs Also See for 81101A:

Table of Contents

Using the HP 81101A

The Mode/Trigger Screen

This section describes the Mode/Trigger screen, starting with an

overview of the available parameter combinations, followed by detailed

descriptions of each combination.

To access the Mode/Trigger screen, press the MODE/TRG softkey.

The following figure shows a typical Mode/Trigger screen, where the

individual parameters are indicated. The parameter combinations are

listed in the table on the next page.

In this screen, you can set up the signal to be triggered or continuous,

and to be a pulse stream or a burst (several pulses followed by a pause)

consisting of single or double pulses.

TRIGGERED BURSTS OF

2-Double-Pulses at Out1

Pulse-Period: internal Osc

Trg'd by: PLL ->

MODE/TRG

Per 2.000 µs

OUTPUT

LIMITS

MODIFY

2.000

µs

TRG-LEV

Table of Contents