HP 81101A Quick Start Manual page 38

Hide thumbs Also See for 81101A:

Table of Contents

Getting Started

Setting Up a Pulse Signal

Programming

If you want to include this pulse signal in your HP-IB program, use the

Example

following command lines. The comment lines starting with a # are not

required.

# Reset the instrument to start from a defined, default status.

*RST

# Switch off the automatic display update to increase programming

# speed.

:DISPlay

# Pulse stream operating mode is required, but as we start

# from a default status it is not necessary to send a command for

# setting the instrument into pulse stream operating mode.

# Set the period to 50 ns, the pulse width to 20 ns, the leading

# edge to 6 ns and the trailing edge to 10 ns.

:PULSe:PERiod

:PULSe:WIDTh

:PULSe:TRANsition

:PULSe:TRANsition:TRAiling:AUTO

:PULSe:TRANsition:TRAiling

# Set the amplitude to 3.3 Volts, the offset to 1.65 Volts.

:VOLTage

:VOLTage:OFFSet

# Enable the output

:OUTPut

OFF

50NS

30NS

6NS

3.3V

1.65V

OFF

10NS

Table of Contents