Table of Contents
Advertisement
To set the timing parameters as required:
1 Press the OUTPUT softkey to enter the Output screen.
2 Press SHIFT + 0 (ON/OFF).
This turns on the Output and activates the internal error check to
detect parameter conflicts.
3 Move the entry focus to P
4 Move the entry focus to the right (to the frequency entry field) and
enter a value of 25 MHz by pressing 2 + 5 +
A warning is displayed, indicating a potential conflict in your settings.
You can ignore this, because the conflict will be solved in the next
steps.
5 Move the entry focus down to W
6 Move the entry focus to the right and enter 50 % by typing 5 + 0 +
ENTER.
7 Move the entry focus down to the leading edge entry field and press 6
+
.
NANO
The trailing edge is set to be the same as the leading edge (T
L
E) by default.
EAD
Freq 25.00MHz Normal
Delay
0.0ps
DtyCyc
50.00%
LeadE
6.00ns
TraiE
=LeadE
MODE/TRG
8 Press SHIFT + MORE (GRAPH) to see a preview of your signal.
and turn the knob to select F
ER
and select D
IDTH
ON
Offset
+0.0mV
Amplit
50Ω into 50.0Ω
OUTPUT
LIMITS
Getting Started
Setting Up a Clock Signal
REQ
/M
.
MICRO
EGA
C
le.
UTY
YC
1
MODIFY
1.00V
6.00
ns
TRG-LEV
.
E =
RAI
31
Advertisement
Table of Contents
