Enabling L2Vpn; Configuring An Ac; Configuring The Interface With Ethernet Or Vlan Encapsulation - HP MSR2000 Configuration Manual

Tasks at a glance
(Required.)
Configuring a
•
(Optional.)
•
(Required.) Choose either of the following tasks to configure a PW:
Configuring a static PW
Configuring an LDP PW
Configuring a BGP PW
Configuring a remote CCC connection
(Optional.)
(Optional.)
•
Configuring static PW redundancy
•
Configuring LDP PW redundancy
(Optional.)

Enabling L2VPN

Before you enable L2VPN, perform the following tasks:
Configure an LSR ID for the PE with the mpls lsr-id command.
•
Enable MPLS with the mpls enable command on the core-facing interface of the PE.
•
For more information about these commands, see MPLS Command Reference.
To enable L2VPN:
Step
1. Enter system view.
2. Enable L2VPN.

Configuring an AC

An AC can be a Layer 3 interface/subinterface.
Configure the Layer 3 interface connected to the CE to create a Layer 2 link between the PE and CE.
The PE forwards packets received from a Layer 3 interface through the bound PW without network layer
processing. Therefore, the Layer 3 interface does not need an IP address.

Configuring the interface with Ethernet or VLAN encapsulation

On a Layer 3 Ethernet interface (including Layer 3 Ethernet interface, Layer 3 virtual Ethernet interface,
and VE-L2VPN interface), both the default PW type and the default access mode are Ethernet. On a
Layer 3 Ethernet subinterface or VLAN interface, both the default PW type and the default access mode
are VLAN.
Configuring a cross-connect
PW:
Configuring a PW class
Binding an AC to a cross-connect
Configuring PW redundancy:
Configuring interworking for a cross-connect
Command
system-view
l2vpn enable
381
Remarks
N/A
Choose a PW configuration
method depending on the MPLS
L2VPN implementation.
Skip these tasks for local
connection configuration.
For multi-segment PWs, skip this
task.
Choose either task to configure
PW redundancy.
N/A
Remarks
N/A
By default, L2VPN is disabled.