To configure a static CRLSP:
Step
1.
Enter system view.
2.
Create a static CRLSP.
Displaying static CRLSPs
Execute display commands in any view.
Task
Display static CRLSP information.
Static CRLSP configuration example
Network requirements
Router A, Router B, and Router C run IS-IS.
Establish an MPLS TE tunnel over a static CRLSP from Router A to Router C. The required bandwidth for
the tunnel is 2000 kbps.
The maximum bandwidth for MPLS TE traffic is 10000 kbps, and the maximum reservable bandwidth is
5000 kbps.
Command
system-view
•
Configure the ingress node:
static-cr-lsp ingress lsp-name { nexthop
next-hop-addr | outgoing-interface
interface-type interface-number }
out-label out-label-value [ bandwidth
[ ct0 | ct1 | ct2 | ct3 ]
bandwidth-value ]
•
Configure a transit node:
static-cr-lsp transit lsp-name in-label
in-label-value { nexthop next-hop-addr |
outgoing-interface interface-type
interface-number } out-label
out-label-value [ bandwidth [ ct0 | ct1 |
ct2 | ct3 ] bandwidth-value ]
•
Configure the egress node:
static-cr-lsp egress lsp-name in-label
in-label-value
Command
display mpls static-cr-lsp [ lsp-name lsp-name ] [ verbose ]
137
Remarks
N/A
Use one command according to
the position of a device on the
network.
By default, no static CRLSP
exists.
Do not configure the next hop
address as a local public IP
address when configuring the
static CRLSP on the ingress
node or a transit node.
You do not need to execute the
static-cr-lsp egress command
on the egress node if the
outgoing label configured on
the penultimate hop of the static
CRLSP is 0 or 3.