HP MSR2000 Configuration Manual page 115

Device
Router B
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address:
For more information, see
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each router. Configure Router
A and Router D to assign a non-null label to the penultimate hop:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.9
[RouterA] mpls label advertise non-null
[RouterA] mpls te
[RouterA-te] quit
[RouterA] rsvp
[RouterA-rsvp] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mpls enable
[RouterA-GigabitEthernet2/1/1] mpls te enable
[RouterA-GigabitEthernet2/1/1] rsvp enable
[RouterA-GigabitEthernet2/1/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] mpls lsr-id 2.2.2.9
[RouterB] mpls te
[RouterB-te] quit
[RouterB] rsvp
[RouterB-rsvp] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mpls enable
[RouterB-GigabitEthernet2/1/1] mpls te enable
[RouterB-GigabitEthernet2/1/1] rsvp enable
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface pos 2/2/0
[RouterB-POS2/2/0] mpls enable
[RouterB-POS2/2/0] mpls te enable
[RouterB-POS2/2/0] rsvp enable
[RouterB-POS2/2/0] quit
# Configure Router C.
<RouterC> system-view
[RouterC] mpls lsr-id 3.3.3.9
[RouterC] mpls te
Interface IP address
Loop0 2.2.2.9/32
GE2/1/1 10.1.1.2/24
POS2/2/0 20.1.1.1/24
"Establishing an MPLS TE tunnel with
Device Interface
POS2/2/0
Router D Loop0
GE2/1/1
106
IP address
20.1.1.2/24
4.4.4.9/32
30.1.1.2/24
RSVP-TE."