HP MSR2000 Configuration Manual page 378

Device
PE 3
Configuration procedure
1. Configure basic IPv6 MPLS L3VPN:
Configure OSPF on the MPLS backbone to allow the PEs and P device to learn the routes of the
loopback interfaces from each other.
Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs.
Establish an MP-IBGP peer relationship between the PEs to advertise VPN IPv6 routes.
Configure the VPN instance of VPN 1 on PE 1 to allow CE 1 to access the network.
Configure the VPN instance of VPN 1 on PE 2 to allow CE 2 to access the network.
Configure the VPN instance of VPN 1 on PE 3 to allow CE 3 to access the network.
Configure BGP as the PE-CE routing protocol, and redistribute routes of the CEs into the PEs.
For more information about basic MPLS L3VPN configurations, see
L3VPNs."
2. Configure BGP AS number substitution:
# Configure BGP AS number substitution on PE 1, PE 2, and PE 3. For more information about the
configuration, see
# Display routing information on CE 2. The output shows that CE 2 has learned the route 100::/96
from CE 1. A routing loop has occurred because CE 1 and CE 2 reside in the same site.
<CE2> display bgp routing-table ipv6 peer 10:2::2 received-routes
Total number of routes: 2
BGP local router ID is 12.1.1.3
Status codes: * - valid, > - best, d - dampened, h - history,
* >e Network : 100::
NextHop : 10:2::2
PrefVal : 0
MED
Path/Ogn: 100 100?
* >e Network : 200::
NextHop : 10:2::2
PrefVal : 0
MED
Path/Ogn: 100 100?
Interface IP address
GE2/1/2 20.1.1.1/24
GE2/1/3 30.1.1.1/24
Loop0 4.4.4.9/32
GE2/1/1 10:3::2/96
GE2/1/2 50.1.1.2/24
"Configuring BGP AS number
s - suppressed, S - stale, i - internal, e - external
Origin: i - IGP, e - EGP, ? - incomplete
:
:
Device Interface
GE2/1/3
P Loop0
GE2/1/1
GE2/1/2
GE2/1/3
substitution."
369
IP address
20.1.1.2/24
3.3.3.9/32
30.1.1.2/24
40.1.1.2/24
50.1.1.1/24
"Configuring IPv6 MPLS
PrefixLen : 96
LocPrf :
OutLabel : NULL
PrefixLen : 96
LocPrf :
OutLabel : NULL