Parameterization With Com Et 200 Windows; Parameterizing And Saving The Configuration (Im 308-C) - Siemens SIMATIC S5 Manual

Procedure – from planning to initial operation
2.4

Parameterization with COM ET 200 Windows

Overview
IM 308-C as DP
master
2-6
This section provides a brief outline of the procedure for parameterization
with COM ET 200 Windows.
When you are ready to parameterize and save the configuration, proceed as
follows:
Table 2-5 Parameterizing and saving the configuration (IM 308-C)
Step
1 After starting COM ET 200 Windows, assign the
p parameters to the individual components:
Bus
Host Host
DP master and
DP slaves DP slaves
Enter the parameters for the DP slaves last, because the
bus, master and host parameters switch on parameters but bus master and host parameters switch on parameters but
you can switch them off again selectively for specific DP
slaves (e g response monitoring error-reporting mode slaves (e.g. response monitoring, error-reporting mode,
etc.).
2 If you have more than one DP master connected to the
bus, create a second master system and again enter all the
requisite parameters.
3 If you have the IM 308-C operating as DP slave, first
create the IM 308-C as DP and then configure the other
parameters in the master system of the IM 308-C/DP
slave.
4 After entering all parameters, save the entire configuration
and transfer (export) the data to memory card. The
memory card is then ready to be inserted in the module
slot of the IM 308-C.
5 Print the system documentation.
Objective
p
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
Additional
information
See Sections
8.2.1 to 8.2.4
See
Section 8.2.9
See
Section 8.2.6
See Section 8.4
See Section 8.5