Adapters For Com Et 200 Windows; Scope Of Application And Preconditions For Using The Com Et 200 Windows Parameterization Software - Siemens SIMATIC S5 Manual

Starting COM ET 200 Windows
7.1 Scope of application and preconditions for using the COM ET 200
Windows parameterization software
Why you need
COM ET 200
Windows
Preconditions for
working with
COM ET 200
Windows
Preconditions for
using COM ET 200
Windows
Preconditions for
using the S5-95U
as DP master
7-2
You need the COM ET 200 Windows parameterization software:
to configure the bus structure, the hosts, the DP masters and DP slaves;
to read the data from a memory card or write data to a memory card, and
to generate detailed system documentation.
COM ET 200 Windows runs under the MS-Windows GUI. We assume that
you are familiar with MS-Windows.
In order to use the full functionality of COM ET 200 Windows, you require:
The MS-DOS operating system, V 5.0 or higher
The MS-Windows GUI, V3.1x or higher
Min. 4 Mbytes free main memory
Min. 5 Mbytes free space on hard disk
386 CPU or faster
To transfer data from COM ET 200 Windows to the S5-95U with DP master
interface, you will require one of the PC/PG adapters listed in Table 7-1.
The adapters are accompanied by detailed instructions for installation. Con-
nect the PG/PC to the SINEC L2 DP bus with a dropline having the order
number 6ES7 901-4BD00-0XA0.
Table 7-1

Adapters for COM ET 200 Windows

Adapter
MPI card 9.6 kbaud to
1.5 Mbaud
DP12-ISA card 9.6 kbaud to
(CP 5411) 12 Mbaud
Baud rate
MPI card is integrated in the
720, 740 and 760 PGs
For connecting 730, 740, 750,
770 PGs and PCs
ET 200 Distributed I/O System
Remarks
EWA 4NEB 780 6000-02a