Teaching in a program
15.6 Selecting a block
15.6
Selecting a block
You have the option of setting the interrupt pointer to the current cursor position. The next
time the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Requirement
The program to be processed is selected.
Proceed as follows
674
1.
Select the "Machine" operating area.
2.
Press the <AUTO> key.
3.
Press the <TEACH IN> key.
4.
Press the "Teach prog." softkey.
5.
Place the cursor on the desired program block.
6.
Press the "Block selection" softkey.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling