Programming technological functions (cycles)
8.5 Contour turning- only for G code programs
8.5.6
Contour call (CYCLE62)
8.5.6.1
Function
Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
2. Labels
3. Subprogram
4. Labels in the subprogram
Procedure
454
The contour is in the calling main program.
The contour is in the calling main program and is limited by the labels that have been
entered.
The contour is located in a subprogram in the same workpiece.
The contour is in a subprogram and is limited by the labels that have been entered.
1.
The part program to be executed has been created and you are in the
editor.
2.
Press the "Turning" and "Contour turning" softkeys.
3.
Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4.
Assign parameters to the contour selection.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling