Tool management
11.6 Tool wear
11.6
Tool wear
All parameters and functions that are required during operation are contained in the tool
wear list.
Tools that are in use for long periods are subject to wear. You can measure this wear and
enter it in the tool wear list. The controller then takes this information into account when
calculating the tool length or radius compensation. This ensures a consistent level of
accuracy during workpiece machining.
Monitoring types
You can automatically monitor the tools' working times via the workpiece count, tool life or
wear.
Note
Combination of monitoring types
You have the option to activate the monitoring of a tool by type or any combination of
monitoring types.
In addition, you can disable tools when you no longer wish to use them.
Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
548
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Meaning
Magazine/location number
The magazine location numbers
•
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine
•
The following icons can also be displayed for other magazine types (e.g.
for a chain):
Spindle location as an icon
•
Locations for gripper 1 and gripper 2 (applies only when a spindle
•
with dual gripper is used) as icons.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling