Table of Contents
Advertisement
The RSTOE (Reset output enable bit) is used to determine whether the
Note
H8/3003 processor outputs reset signal when the processor is reset by
the watchdog timer. However, the H8/3003 emulator ignores the
configuration of the RSTOE, and works as it is configured with cf drst
command.
cf mode
The mode (cpu operation mode) configuration item defines operation
mode in which the emulator works.
The emulator will work using the mode setting by the target system.
The target system must supply appropriate inputs to MD0, MD1 and
MD2.
When <mode_num> is selected, the emulator will operate in selected
mode regardless of the mode setting by the target system.
Valid <mode_num> are following:
<mode_num>
1
2
3
4
5
M> cf mode=ext
M> cf mode=<mode_num>
Description
The emulator will operate in mode 1. (expanded 1M
bytes mode without internal ROM: 8 bit data bus)
The emulator will operate in mode 2. (expanded 1M
bytes mode without internal ROM:16 bit data bus)
The emulator will operate in mode 3. (expanded
16M bytes mode without internal ROM: 8 bit data
bus)
The emulator will operate in mode 4. (expanded
16M bytes mode without internal ROM:16 bit data
bus)
The emulator will operate in mode 5. (expanded 1M
bytes mode with internal ROM: 8 bit data bus)
Configuring the Emulator 4-9
Advertisement
Table of Contents
