Table of Contents
Advertisement
Before You Begin
2-2 Getting Started
Before beginning the tutorial presented in this chapter, you must have
completed the following tasks:
1. Completed hardware installation of the HP 64700 emulator in
the configuration you intend to use for your work:
Standalone configuration
Transparent configuration
Remote configuration
2. If you are using the Remote Configuration, you must have
completed installation and configuration of a terminal
emulator program which will allow your host to act as a
terminal connected to the emulator. In addition, you must start
the terminal emulator program before you can work the
examples in this chapter.
3. If you have properly completed steps 1 and 2 above, you
should be able to hit <RETURN> (or <ENTER> on some
keyboards) and get one of the following command prompts on
your terminal screen:
U>
R>
M>
If you do not see one of these command prompts, retrace your
steps through the hardware and software installation
procedures outlined in the manuals above, verifying all
connections and procedural steps. If you are still unable to get
a command prompt, refer to the HP 64700 Support Services
Guide. The guide gives basic troubleshooting procedures. If
this fails, call the local HP sales and service office listed in the
Support Services Guide.
In any case, you must have a command prompt on your
terminal screen before proceeding with the tutorial.
Advertisement
Table of Contents
