Table of Contents
Advertisement
Emulator Specific
Error Messages
Message
Message
Message
The following is the error messages which are specific to the H8/3003
emulator. The cause of the errors is described, as well as the action you
must take to remedy the situation.
140 : Stack is in I/O registers
Cause
This error occurs when you attempt to execute user program (with r or s
command) with the stack pointer set at internal I/O register area.
Action
Set up the stack pointer with cf rsp command. Refer to chapter 3 of this
manual for more information.
141 : Invalid address for run or step in current mode
Cause
This error occurs when you attempt to execute user program (with r or s
command) from address over area of current mode.
170 : Emulation memory card not found in card cage
Cause
This error occurs when you don't insert memory board in card cage, or
connect memory board which is not supported.
Action
Insert correct memory board.
H8/3003 Emulator Specific Command Syntax A-15
Advertisement
Table of Contents
