HP H8/3003 User Manual page 93

Note
Note
Note
cf drst
4-8 Configuring the Emulator
You use the dbc option to avoid target system interaction problems.
For example, your target system interaction scheme may depend on the
constant repetition of bus cycles. In such case, using the dbc option
will help avoid the problem.
Refresh cycles, internal DMA cycles and target memory access are
always driven to the target system regardless of this configuration.
When dbc is disabled, the emulator can't respond to /WAIT signal.
Executing this command will drive the emulator into the reset state.
The drst (drive reset) configuration item allows you to specify whether
or not the emulator drives the /RESO signal to the target system by the
Watchdog Timer.
M> cf drst=dis
The above command configures the emulator not to drive the reset
signal to the target.
M> cf drst=en
The emulator will drive the reset signal to the target system by the
Watchdog Timer.