Siemens SINUMERIK 840D sl Operating Manual page 665

References
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
Graphic display of tools and magazine locations
Figure 13-19 Graphic display of tools and magazine locations
The following applies to the graphic display:
● If a tool is too long for the display, the maximum possible length is shown.
● Oversized tools are trimmed on the left and right sides.
● Tools that are not located in the magazine are displayed without toolholder.
● Disabled tools or magazine locations are marked by means of a red cross:
Milling
Operating Manual, 05/2017, A5E40868956
Tool management
13.11 Graphic display
665