Machining the workpiece
6.7 Starting machining at a specific point
Procedure
6.7.4
Defining an interruption point as search target
Requirement
A program was selected in "AUTO" mode and interrupted during execution through CYCLE
STOP or RESET.
Procedure
168
1.
Press the "Block search" softkey.
2.
Place the cursor on a particular program block.
- OR -
Press the "Find text" softkey, select the search direction, enter the
search text and confirm with "OK".
3.
Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into ac‐
count.
The current block will be displayed in the "Program" window as soon
as the target is found.
4.
If the located target (for example, when searching via text) does not
correspond to the program block, press the "Start search" softkey again
until you find your target.
Press the <CYCLE START> key twice.
Processing is continued from the defined position.
Software option
You require the "Extended operator functions" option (only for 828D).
1.
Press the "Block search" softkey.
2.
Press the "Interrupt point" softkey.
The interruption point is loaded.
Operating Manual, 05/2017, A5E40868956
Milling