Enabling Snmp Notifications For Ipv6 Pim; Enabling Nbma Mode For Ipv6 Advpn Tunnel Interfaces - HP MSR1002-4 Configuration Manual

Hardware
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A)
MSR958 (JH300A/JH301A)
MSR1002-4/1003-8S
MSR2003
MSR2004-24/2004-48
MSR3012/3024/3044/3064
MSR4060/4080
This feature enables IPv6 PIM to back up protocol state information, including IPv6 PIM neighbor
information and routes, from the active process to the standby process. The standby process
immediately takes over when the active process fails. Use this feature to avoid route flapping and
forwarding interruption for IPv6 PIM when an active/standby switchover occurs.
To enable IPv6 PIM NSR:
Step
1. Enter system view.
2. Enable IPv6 PIM NSR.

Enabling SNMP notifications for IPv6 PIM

To report critical IPv6 PIM events to an NMS, enable SNMP notifications for IPv6 PIM. For PIM event
notifications to be sent correctly, you must also configure SNMP as described in Network
Management and Monitoring Configuration Guide.
To enable SNMP notifications for IPv6 PIM:
Step
1. Enter system view.
2. Enable SNMP notifications
for IPv6 PIM.

Enabling NBMA mode for IPv6 ADVPN tunnel interfaces

This feature allows IPv6 ADVPN tunnel interfaces to forward IPv6 multicast data to target spokes
and hubs. For more information about ADVPN, see Layer 3
Configuration restrictions and guidelines
When you enable NBMA mode, follow these restrictions and guidelines:
•
This feature is not available for IPv6 PIM-DM.
•
This feature takes effect only when IPv6 PIM-SM is enabled.
•
In an IPv6 BIDIR-PIM domain, make sure RPs do not reside on IPv6 ADVPN tunnel interfaces
or on the subnet where IPv6 ADVPN tunnel interfaces are located.
Command
system-view
ipv6 pim non-stop-routing
Command
system-view
snmp-agent trap enable pim6
[ candidate-bsr-win-election |
elected-bsr-lost-election
neighbor-loss ] *
362
IPv6 PIM NSR compatibility
No
No
No
Yes
Yes
Yes
Yes
Remarks
N/A
By default, IPv6 PIM NSR is
disabled.
Remarks
N/A
By default, SNMP notifications for
| IPv6 PIM are enabled.
—
IP Services Configuration Guide.