Displaying And Maintaining Multicast Vpn - HP MSR1002-4 Configuration Manual

to improve network reliability. To avoid routing loops, make sure the route reflectors in a cluster have
the same cluster ID.
Perform this task on PE devices.
To configure a BGP MDT route reflector:
Step
1. Enter system view.
2. Enter BGP instance view.
3. Enter
address family view.
4. Configure the device as a
route reflector and specify its
peers or peer groups as
clients.
5. (Optional.)
reflection between clients.
6. (Optional.)
cluster
reflector.

Displaying and maintaining multicast VPN

Execute display commands in any view and reset commands in user view.
Task
Display BGP MDT peer group
information.
Display information about BGP
MDT peers or peer groups.
Display BGP
information.
Display information about BGP
update groups for the BGP IPv4
MDT address family.
Display
data-groups that are received in
the MD of a VPN instance for IPv4
multicast transmission.
Display
data-groups that are received in
the MD of a VPN instance for IPv6
multicast transmission.
BGP IPv4 MDT
Disable route
Configure the
ID of the route
Command
display bgp [ instance instance-name ] group ipv4 mdt
[ group-name group-name ]
display bgp [ instance instance-name ] peer ipv4 mdt [ ip-address
mask-length | { ip-address | group-name group-name } log-info |
[ ip-address ] verbose ]
display bgp [ instance instance-name ] routing-table ipv4 mdt
MDT routing
[
[ advertise-info ] ]
display bgp [ instance instance-name ] update-group ipv4 mdt
[ ip-address ]
display
information about
data-group receive [ brief | [ active | group group-address | sender
source-address | vpn-source-address [ mask { mask-length | mask } ] |
vpn-group-address [ mask { mask-length | mask } ] ] * ]
information about display multicast-domain vpn-instance vpn-instance-name ipv6
data-group receive [ brief | [ active | group group-address | sender
source-address
vpn-group-address [ mask-length ] ] * ]
Command
system-view
bgp instance
as-number [
instance-name ]
address-family ipv4 mdt
peer { group-name | ip-address
[ mask-length ] } reflect-client
undo reflect between-clients
reflector cluster-id { cluster-id |
ip-address }
route-distinguisher
multicast-domain
| vpn-source-address
200
Remarks
N/A
N/A
N/A
By default, neither route reflectors
nor clients exist.
By default, route reflection between
clients is disabled.
For more information about this
command, see
Routing Command Reference.
By default, a route reflector uses its
router ID as the cluster ID.
For more information about this
command, see
Routing Command Reference.
route-distinguisher ]
vpn-instance vpn-instance-name
[ mask-length
Layer 3—IP
Layer 3—IP
[ ip-address
] |