Configuring Ipv6 Pim-Ssm; Ipv6 Pim-Ssm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Sm - HP MSR1002-4 Configuration Manual

Step
3. Disable the device from
sending
incoming interfaces.

Configuring IPv6 PIM-SSM

IPv6 PIM-SSM requires MLDv2 support. Enable MLDv2 on IPv6 PIM routers that connect to
multicast receivers.

IPv6 PIM-SSM configuration task list

Tasks at a glance
(Required.)
(Optional.) Configuring the IPv6 SSM group range
(Optional.) Configuring common IPv6 PIM features

Configuration prerequisites

Before you configure IPv6 PIM-SSM, configure an IPv6 unicast IPv6 routing protocol so that all
devices in the domain can interoperate at the network layer.

Enabling IPv6 PIM-SM

Before you configure IPv6 PIM-SSM, you must enable IPv6 PIM-SM, because the implementation of
the IPv6 SSM model is based on subsets of IPv6 PIM-SM.
When you deploy an IPv6 PIM-SSM domain, enable IPv6 PIM-SM on non-border interfaces of the
routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Step
1. Enter system view.
2. Enable IP multicast routing,
and enter MRIB view.
3. Return to system view.
4. Enter interface view.
5. Enable IPv6 PIM-SM.
BSMs out of
Enabling IPv6 PIM-SM
Command
undo bsm-reflection enable
Command
system-view
ipv6 multicast
[ vpn-instance
vpn-instance-name ]
quit
interface
interface-type
interface-number
ipv6 pim sm
355
Remarks
By default, the device sends
BSMs out of incoming interfaces.
Remarks
N/A
routing
By default, IPv6 multicast routing
is disabled.
N/A
N/A
By default, IPv6 PIM-SM is
disabled.