Configuring Ipv6 Pim-Sm; Ipv6 Pim-Sm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Sm - HP MSR1002-4 Configuration Manual

For more information about the configuration of other timers in IPv6 PIM-DM, see
common IPv6 PIM

Configuring IPv6 PIM-SM

This section describes how to configure IPv6 PIM-SM.

IPv6 PIM-SM configuration task list

Tasks at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
(Optional.)
Configuring a
•
(Required.)
•
(Optional)
incoming interfaces
•
(Optional.)
•
(Optional.)
(Optional.) Configuring IPv6 multicast source registration
(Optional.) Configuring the switchover to SPT
(Optional.) Configuring common IPv6 PIM features

Configuration prerequisites

Before you configure IPv6 PIM-SM, configure an IPv6 unicast routing protocol so that all devices in
the domain can interoperate at the network layer.

Enabling IPv6 PIM-SM

Enable IPv6 multicast routing before configuring IPv6 PIM.
With IPv6 PIM-SM enabled on interfaces, routers can establish IPv6 PIM neighbor relationship and
process IPv6 PIM messages from their IPv6 PIM neighbors. As a best practice, enable IPv6 PIM-SM
on all non-border interfaces on routers when you deploy an IPv6 PIM-SM domain.
IMPORTANT:
All the interfaces on the same router must operate in the same IPv6 PIM mode in the public network
or the same VPN instance.
To enable IPv6 PIM-SM:
Step
1. Enter system view.
timers."
Enabling IPv6 PIM-SM
Configuring an RP:
Configuring Anycast RP
BSR:
Configuring a C-BSR
Disabling BSM forwarding out of
Configuring an IPv6 PIM domain border
Disabling BSM semantic fragmentation
Remarks
N/A
You must configure a static RP, a C-RP, or both
in an IPv6 PIM-SM domain.
Skip the task of configuring a BSR on a network
without C-RPs.
N/A
N/A
N/A
Command
system-view
343
"Configuring
Remarks
N/A