Intra-As M6Vpe Configuration Example - HP MSR1002-4 Configuration Manual

Verifying the configuration
# Display information about the local default-group for IPv4 multicast transmission in each VPN
instance on PE 1.
[PE1] display multicast-domain default-group local
MD local default-group information:
Group address
239.1.1.1
# Display information about the local default-group for IPv4 multicast transmission in each VPN
instance on PE 2.
[PE2] display multicast-domain default-group local
MD local default-group information:
Group address
239.1.1.1
239.1.1.1
# Display information about the local default-group for IPv4 multicast transmission in each VPN
instance on PE 3.
[PE3] display multicast-domain default-group local
MD local default-group information:
Group address
239.1.1.1
239.2.2.2

Intra-AS M6VPE configuration example

Network requirements
As shown in
Item
Multicast
receivers
VPN instances to which PE
interfaces belong
Unicast routing protocols and
MPLS
Source address
1.1.1.1
Source address
1.1.1.2
1.1.1.2
Source address
1.1.1.3
1.1.1.3
Figure 72, configure intra-AS M6VPE to meet the following requirements:
Network requirements
•
•
sources and
•
•
•
•
•
•
•
•
Interface
MTunnel0 a
Interface
MTunnel0 a
MTunnel1 b
Interface
MTunnel0 a
MTunnel1 b
In VPN instance a, S 1 is a multicast source, and R 1, R 2, and R 3 are
receivers.
In VPN instance b, S 2 is a multicast source, and R 4 is a receiver.
For VPN instance a, the default-group is 239.1.1.1, and the
data-group range is 225.2.2.0 to 225.2.2.15.
For VPN instance b, the default-group is 239.2.2.2, and the
data-group range is 225.4.4.0 to 225.4.4.15.
PE 1: GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 belong to VPN
instance a. GigabitEthernet 1/0/1 and Loopback 1 belong to the public
network.
PE 2: GigabitEthernet 1/0/2 belongs to VPN instance b.
GigabitEthernet 1/0/3 belongs to VPN instance a. GigabitEthernet
1/0/1 and Loopback 1 belong to the public network.
PE 3: GigabitEthernet 1/0/2 belongs to VPN instance a.
GigabitEthernet 1/0/3 and Loopback 2 belongs to VPN instance b.
GigabitEthernet 1/0/1 and Loopback 1 belong to the public network.
Configure OSPF on the public network, and configure OSPFv3
between the PE devices and the CE devices.
Establish BGP peer connections between PE 1, PE 2, and PE 3 on
their respective Loopback 1.
Configure MPLS on the public network.
214
VPN instance
VPN instance
VPN instance