Table of Contents
Advertisement
Using the installation wizard
Attribute
Cable Loss
Maximum Power
Level
Modulation Mode
Encryption Key
(64 characters)
Step 3: Date and time settings
Step 3 of the Installation wizard is for setting the date and time
attributes are described in
The clock supplies accurate date and time information to the system. It can be set to run
with or without a connection to a Network Time Protocol (NTP) server:
•
In the absence of an NTP server connection, the clock can be set to run manually. The
clock is battery backed and will continue to operate for several days after the ODU is
switched off.
•
If an NTP server connection is available, the clock can be set to synchronize with the
server time at regular intervals.
6-18
Meaning
Loss (dB) in the RF cable between the ODU and the antenna.
If there is a significant difference in length of the antenna cables
for the two antenna ports, then enter the average value.
The maximum power (dBm) at which the unit will transmit.
The highest value in the list is automatically constrained to be
within regulatory limts, based on the values entered in Antenna
Gain and Cable Loss.
The modulation mode used on the transmit channel. The
recommended setting is 'Adaptive'.
Key to be used for link encryption. The same key must be used at
both ends of the link.
Table 6-3.
Update the attributes as required and select Next.
UNDER DEVELOPMENT
Chapter 6: Configuration and alignment
(Figure
6-16). The
phn-2182_003v004 (Oct 2011)
Advertisement
Table of Contents
