Figure 5-2 Lightning Arrestor Mounting - Motorola PTP 250 User Manual

PTP 250 User Guide
5
If the ODU is mounted outdoors, weatherproof the N type connectors fitted to the
ODU by following the procedure
12. Weatherproof the antenna joints in the same way (unless the antenna
manufacturer specifies a different method).
6
Ground the antenna cables to the supporting structure at the correct points
(Figure
antennas using the using the cable grounding kit (part number 01010419001).
A mast or tower may require additional grounding points, as specified in
Protection requirements for a mast or tower installation
7
Dress the antenna cables and attach them to the supporting structure using site
approved methods.
Ensure that no undue strain is placed on the ODU or antenna connectors. Ensure
that the cables do not flap in the wind, as flapping cables are prone to damage
and induce unwanted vibrations in the supporting structure.

Figure 5-2 Lightning arrestor mounting

phn-2182_003v004 (Oct 2011)
5-4). They should be grounded within 0.3 meters (1 foot) of the ODU and
Weatherproofing an N type connector
UNDER DEVELOPMENT
Installing connectorized antennas
on page
on page 2-18.
5-
5-9