D-Link DWC-1000 User Manual page 157

Section 5 - Advanced Network Configuration
Reconnect Mode
Field
DNS Server Source
Primary DNS Server
Secondary DNS Server Enter the secondary DNS server.
MAC Address Source
MAC Address
MTU Size
Custom MTU Size
Port Speed
D-Link DWC-1000 User Manual
Select one of the following options:
• Always On: The connection is always on.
• On Demand: The connection is automatically ended if it is idle for a specified number
of minutes. Enter the number of minutes in the Maximum Idle Time field. This feature is
useful if your ISP charges you based on the amount of time that you are connected.
Select one of the following options:
• Get Dynamically from ISP: Select this option if your ISP did not assign a static DNS IP
address.
• Use These DNS Servers: Select this option if your ISP assigned a static DNS IP address
for you to use. Also complete the fields below.
Enter the primary DNS server.
Select Use Default MAC unless your ISP requires MAC authentication and another MAC
address has been previously registered with your ISP. In that case, choose one of the following
options:
• Clone your PC's MAC Address: Select this option to assign the MAC address of the
computer that you are using to configure the controller.
• Use this MAC Address: Select this option if your ISP assigned a MAC address for you to
use. Also complete the fields below.
Enter a MAC address in the following format: XX:XX:XX:XX:XX:XX where X is a number from 0
to 9 (inclusive) or an alphabetical letter between A and F (inclusive).
The MTU (Maximum Transmit Unit) is the size of the largest packet that can be sent over the
network. The standard MTU value for Ethernet networks is usually 1500 Bytes and for PPPoE/
PPTP connections, it is 1492 Bytes. For all l2tp connections, it is 1460 Bytes.
Enter a specific MTU size.
The Ethernet port speed can be manually set or specified depending on your Option1/
Option 2 requirements.
Description
DNS Servers
MAC Address
Port Setup
157