Mitsubishi Electric Q26UD(E)HCPU User Manual page 350

Error
Error and cause
code
[LOAD ERROR]
Reading of batch-save/load target data from the
SD memory card failed.
■Collateral information
2241
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
A system file (SVLDINF.QSL) does not exist in the
load-target folder.
■Collateral information
2242
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
The file password 32 of the load-destination file is
different from that of the load-source file. Or, a file
password 32 is not set to the load-source file while
the load-destination file has a password.
2243
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
• When the folder number (1 to 99) is set in
SD909 (Auto loading target folder number), a
folder with the corresponding number does not
exist in the SD memory card.
• The folder number out of the setting range
2244
(other than 0 to 99) is set in SD909 (Auto
loading target folder number).
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
Loading data to the load-destination drive has
failed.
■Collateral information
2245
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
• When the folder number (1 to 99) is set in
SD909 (Auto loading target folder number), an
SD memory card is not inserted.
• When the folder number (1 to 99) is set in
SD909 (Auto loading target folder number), the
2246
SD memory card access control switch of the
CPU module is not slid down.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
348
Corrective action
Execute auto loading using any other data
because the batch-save/load target data may
be corrupted.
Specify a folder where a system file
(SVLDINF.QSL) is stored, and execute auto
loading.
Set the same file password 32 to the load-
destination file and the load-source file, and
execute auto loading.
• Check that a folder with the number
corresponding to the one set in SD909
exists in the SD memory card, and execute
auto loading.
• Set the number in SD909 within the setting
range, and execute auto loading.
The possible cause is a failure of the CPU
module. Execute auto loading to another
CPU module.
• Insert an SD memory card, and execute
auto loading.
• Slide up the SD memory card access
control switch, and execute auto loading.
LED status, Corresponding
CPU status
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
CPU